WTB: Stock 205 Power and Output transformer

If you're moving gear or getting some gear this is the place to check out ... beware of GAS attacks ! If you are selling a JVM please state why you are selling.

Moderators: jim renolds, jimsreynolds, Jackie, Andy

Forum rules
If you are selling a JVM please state why you are selling.
Post Reply
namklak
Private Parties
Posts: 288
Joined: Fri Oct 28, 2016 3:16 pm
Location: Denver, CO

WTB: Stock 205 Power and Output transformer

Post by namklak » Sun Oct 29, 2017 12:44 am

Y'all,
I'm in the US and would like to purchase one each stock 205 Power Transformer and Output Transformer. I know some have swapped these out for after-market components, so you may just have these laying around...
Thanks!!!
JVM205h. Added 100K from R94/C43 to ground for V1b (OD Channel) gain reduction. Installed 1000pF in series with 47K, in parallel with R58 (82K), to reduce power amp squeal. V3 Valve Wizard diode protection mod. Active power soak for more EL34 goodness.
Guitars: Angus Young Sig SG w/ Pearly Gates Neck and Custom Custom Bridge, Les Paul Special (2 pups) w/ SD Stacked P90s. And occasionally a Warmoth Strat w/ Dimarzio True Velvet in N, M, SD P-Rails in B.
HD500x in 4CM for all pedals and Midi control of 205h (grounds lifted on two of the signal cables).

Post Reply